In the process of glass partition installation in the office, the decoration owner pays close attention to its construction technology and installation process. In the face of glass partition decoration, there are actually a variety of installation methods. Today, Jinan glass partition is introduced to you is one of the nailing method of installation.
Installation of glass partition nailing requires smooth wall treatment without bulging or bumping. If the wall is smooth enough, it can be directly used for installation. Otherwise, cement mortar can be used (if appropriate moisture-proof powder can be added, the effect is better) to scrape and leveling once.
Each piece of glass needs to drill four fixing holes. The holes should be evenly distributed and not too close to the edge of the glass to prevent cracking. Now the fixed wall glass partition sold on the market has generally been drilled installation holes, non-shaped glass partition can be drilled in professional processing points.
Installation of office glass partition should first play a good line on the wall, then place the glass partition in the corresponding position of the wall, mark the holes on the glass, remove the glass, drill or hammer the holes on the wall, the hole size should be determined according to the selected screw size, generally smaller than or equal to the size of the screw. The diameter of the screw end is 3 mm.
Before installing glass, a protective layer of kraft paper should be pasted on the back of the glass. The specific method is to apply a layer of latex on the back of the glass, then paste a kraft paper on the back of the mirror, and then scrape it flat with a plastic plate. The plastic expansion bolt is embedded in the hole punched on the wall. The glass is positioned in the right place, fixed with screw and tightened diagonally. It is better to keep the glass stable without shaking.
After fixing the glass around the seal, in order to prevent moisture from intruding into the back of the glass and affecting the service life and quality of the glass partition, the gap between the glass and the wall should be filled with seam paste.
If you have more comments and ideas, please leave a message online: http://www.wshdgj.com, we will have someone to connect with you later!